Drivetrain Articles

Converting an Automatic to Five Speed Manual
1980 280 ZX
.

Blister writes:.

Hi Doc,.

A crazy driver ran a red light and totaled out my 1980 280 ZX a couple of weeks ago. I’ve found another 1980 280 ZX with a cherry body. I had just had a brand new factory engine installed in my 5 speed totaled Z and was in the process of restoring it. The one that I found is an automatic. My question is can I put my new engine and the 5 speed into the automatic Z without too much trouble?? I know the engine is no problem but the 5 speed needs the clutch and brake pedal changed..

Any help or suggestions will be greatly appreciated..

.

Thanks,
Blister
.

Doc replies:.

Hi there,.

Doc here, Yes you can changeover the automatic with the stick components. The engine swap with transmission will use the same mounts. The drive shaft should be the same, but you must lay them side by side to see if they are the same length and that the yokes are the same slip fit. The pedal assembly will have to be changed over and the plate is there in the firewall to remove so that you can install the clutch master cylinder and steel; line that goes to the clop on the passenger's side of the lower frame rail. The flex hose to the clutch slave should fit right up. The hole in the console I believe will have
the stick come out in the same place too. Save your wreck in case you don't like the gear ratio in the rear differential, you will want to exchange the R-200 differential from the damaged unit. I am not certain but I believe that they have different gear ratios, so you need to make that determination. All the electricals, and the EFI system will interchange with the old unit..

Are these Federal cars or California SMOG equipment? You will need to get the donor Smogged after you complete the transfer. I don't think that the ECU's are different, but you must check that too. Do both engines have the O2 sensor in the
exhaust manifold? The production dates should indicate similarities..

I hope that this helps you.......Are you a ZONC Member?........ How did you hear about me?..........

ZDOC OUT.

.

Blister replies:.

Hi Doc,.

Thanks for answering my questions so promptly. You were a big help. When I get all done with this project, I'll let you know what, if any problems I had. It’ll take me a few weeks maybe even a couple of months but I’ll get back to you..

I bought both Zs from the original owners, and they are California smog equipped. That was one of my first concerns so I called Motor V. and they said they didn't see any problem as long as I’m installing the same engine. The only problem they could think of is the idle and timing settings, I looked them up in my Z manual and they are the same..

I’m not a ZONC member, I found their Web Site through the Sacramento Bee. I found you through their Web Site and I’m sure glad that I did, you’ve been a great help..

Blister .

.

 

 
Phil's 300ZX Fairlady Transmission Problems
Ralph's '90 300ZX Transmission and Clutch Problems
280ZX Rearend Swap
300ZX Twin Turbo Clutch Slipping
'81 Z with Noisy Bearing in 5-speed
Noisy Rear Axles
"That's what I get for going to "Clutch Mart" - Clutch Problems
"Performance" clutches - Centerforce
Converting an Automatic to Five Speed Manual
More on Converting an Automatic to Five Speed Manual
 

"Thats what I get for going to Clutch-Mart" "Frosty" wrote Doc: "That is what I get for getting the job done at "Clutch Mart", And yes there is noise when the clutch is disengaged or the trans is in neutral. Any info will help." Read Doc's answer to Frosty and other Datsun enthusiasts who have sought his advise for the last couple decades on Doc's Tech pages.

 

Nissan IMSA Racer #83 For Sale Nissan IMSA racer #83 for sale1992 Nissan GTP ZX Turbo is being offered for sale by Canepa Design, Scotts Valley, California. Nissan GTP cars won four straight championships from ’88-’91.After Nissan shut down it’s IMSA racing team chassis 90-06 was destined for Nissan’s corporate museum, somehow that didn't happen and now it is for sale!


Doc Joins other members of ZONC at the Blackhawk Automotive Museum A Datsun / Nissan extravaganza is being held at The Blackhawk Automotive Museum on June 30th. Look for Doc's photos and a report of the event here in the next few days.

280Z Dies SudenlyTravis here(Zonc #98029), in Fresno. I have a problem with my 1977 280z which I can not figure out. It started today. Just driving down the road the car shut off, I disengaged the clutch and it started right back up. I drove it home only about a mile. Tonight I drove it to FSU and it shut off 3 times on the way there, while it was cold and running at temp. I just hooked up a test light to the fuel pump and drove the car. The light is inline with the pump so when the pump is getting power the light is on.
Read Doc's Solution

Got a an old Datsun / Nissan you don't want? We are always looking for old Datsun / Nissan vehicles. Let Doc's team know if you want one or have one. Doc is alway up for making someone happy with a new Datsun / Nissan project.
We are also happy to list your Datsun / Nissan in our new cars for sale section of this site, email or call us for details. We have no cars presently for sale - so let us know if you have one.

Rare parts - Doc cleans out his garage Due to limited space at Doc's Auto Clinic's location Doc is being forced to clean up his shop. He is uncovering forgoten NOS (new-old-stock vintage) Datsun and Nissan parts every week. If you need a part email or call Doc. He might have it... somewhere.

©2007 Docs Auto Clinic